Page 2 of 2

Re: Help with network output

Posted: Mon Feb 10, 2020 6:37 pm
by animism
Side note; I'm now getting a small popup saying "24" (see attached), which happens when processing the x264 portion of my workflow. I wasn't seeing this before, so perhaps it's caused by the new processors file? I have to hit "OK" for it to proceed, then it finishes the process successfully. Any ideas what's causing that?

Re: Help with network output

Posted: Mon Feb 10, 2020 9:19 pm
by admin
Oh dear! Eh, well, you're actually running a version of the processor that was ment to be an update for the 0.9.4 branch but never released. So it might have some peculiarities.
Try this new attached.

-steinar

Re: Help with network output

Posted: Mon Feb 10, 2020 11:14 pm
by animism
And that appears to have fixed it! I'm blown away by your support, thank you again.