Page 1 of 1
Autolt error
Posted: Fri Jul 15, 2016 7:17 pm
by Rubikean
On a clean install, I get the following error box when trying to create a workflow-
Line 48761 (path to ffastrans.exe)
Error: Variable used without being declared.
Upon clicking ok, ffastrans exits. This exact condition exists on all 3 machines I've tried to run ffastrans on.
Any suggestions?
-Chris
Re: Autolt error
Posted: Fri Jul 15, 2016 7:34 pm
by admin
What version are you running?
Re: Autolt error
Posted: Fri Jul 15, 2016 7:40 pm
by Guest
0.7.5, I just downloaded it. I can bring in my old workflows, but get the error when I try to add anything to the canvas.
-Chris
Re: Autolt error
Posted: Fri Jul 15, 2016 7:42 pm
by Rubikean
Sorry, I didn't realized I wasn't logged in.
Version 0.7.5
-Chris
Re: Autolt error
Posted: Fri Jul 15, 2016 8:31 pm
by admin
Hi, I've located the source of the error and it should only occur when you try to insert a new processor node. Can you please confim this? Also, can you recreate the error at will and describe exactly what you're doing? The reason I'm asking is because I have never seen this problem before and I cannot seem to recreate it myself unless I alter the code to make it happen.
-steinar
Re: Autolt error
Posted: Fri Jul 15, 2016 9:26 pm
by Rubikean
Yes, you are exactly correct. I right click and add monitor folder or encode node, the error occurs every time.
The process to create error-
Launch ffastrans.exe (I tried moving ffastrans folder on root, desktop, and downloads folder).
Right click- monitor- folder
Autolt error dialog box appears.
Is this user error?
-Chris