To Move Source to different location after transcoding

Questions and answers on how to get the most out of FFAStrans
Post Reply
dinesh24
Posts: 29
Joined: Fri Oct 06, 2017 7:01 am

To Move Source to different location after transcoding

Post by dinesh24 »

We need the FFAStrans moulde for move source file to different location after transcoding. Below is image for workflow.
Please let me know there is any option is available in FFAStrans.
Attachments
Workflow.PNG
Workflow.PNG (25.14 KiB) Viewed 6674 times
admin
Site Admin
Posts: 1687
Joined: Sat Feb 08, 2014 10:39 pm

Re: To Move Source to different location after transcoding

Post by admin »

Please add the "Command executor" node and take a look at the help section.

-steinar
dinesh24
Posts: 29
Joined: Fri Oct 06, 2017 7:01 am

Re: To Move Source to different location after transcoding

Post by dinesh24 »

Thanks for help.. Issue is that file is in watch folder for transcoding , i didn't know which process has been first completed there are two process first is custom ffmpeg for mp4 creation and AVC intra. i am confuse where i can add command executor.
admin
Site Admin
Posts: 1687
Joined: Sat Feb 08, 2014 10:39 pm

Re: To Move Source to different location after transcoding

Post by admin »

You can connect the two destination "Folder" nodes to a "Hold" node and activate synchronize. Then you connect the "Command executor" to the "Hold" node. With that approach FFAStrans will wait at the "Hold" for the two branches to reach the same point, and then continue. But be aware that there are still two branches. So when adding the "Command executor" node to delete the source file, one of the branches should fail. This is logical and as expected.

-steinar
dinesh24
Posts: 29
Joined: Fri Oct 06, 2017 7:01 am

Re: To Move Source to different location after transcoding

Post by dinesh24 »

Thanks you so much for help...
Post Reply