Page 1 of 1
Variable | Start TC | Wrong Result
Posted: Fri May 07, 2021 1:15 pm
by taner
Hi Admin-Team,
I'm not sure if it is a bug.
When I read out the start timecode of an av-file via start tc-variable I get wrong results.
I tried it with several files.
Original start tc is: 01:00:00:00
Read-out value is: 00:00:00:00
Just a quick info.
I haven't had the time to make further tests.
I'm using the latest FFAStrans-version.
Best
Taner
Re: Variable | Start TC | Wrong Result
Posted: Fri May 07, 2021 6:13 pm
by admin
Hi Taner,
Can you please share either a short example file or the job log from one of the job showing the issue? In the inbuilt status monitor right click on a job and select "Open log folder...", zip the content and send it so I can investigate. If not, please upload a sample file to
http://ffastrans.com/share
-steinar
Re: Variable | Start TC | Wrong Result
Posted: Sat May 08, 2021 8:53 am
by momocampo
Hi Taner,
As Steinar said, please give us more informations cause I tested and it was ok for me with the latest version.
thanks.
B.
Re: Variable | Start TC | Wrong Result
Posted: Sat May 08, 2021 11:16 am
by Ghtais
I think it should depend what kind of file you transcode.
I'am using this variable with a tone of different files and codec and I had no issue with it.
Re: Variable | Start TC | Wrong Result
Posted: Sat May 08, 2021 2:06 pm
by taner
Thanks for your suggestions guys!
I‘ve sent Steinar all relevant files.
Re: Variable | Start TC | Wrong Result
Posted: Sat May 08, 2021 9:32 pm
by admin
Hi Taner,
Thanks for the file. It's nothing wrong with your file so you found a bug in FFAStrans. It's fixed for the upcoming 1.2.1 version.
Thanks for reporting!
-steinar