FFAStrans forum

Hi,

recently I have a problem with an older workflow. The workflow should analyse a media file and transcode it depending on its framerate to a mxf file.
The workflow works fine, but since I use Ffastrans with 2 new PCs I always get a MediaInfo popup after Fasttrans has finished analyzing the media file.
Unfortunately the workflow waits for me to close the windows before the next step is started - in my case the "indexing" comes next.

Is there somewhere I can stop MediaInfo showing the results?

Ffastrans (0.7.7) is started from a network drive and both PCs are configured to "share" the workfolder.

Thanks,
silverline

Hm, that's strange, I've never seen or heard of this. MediaInfo is only shipped with the command line version. Can you please take a screen shot of the issue?

-steinar

Ok,
stupid me! I updates Ffastrans to the latest version and copied my own processor goodies from the old version... then I copied the MediaInfo full version from a different folder and overwrote the command line version... sorry. Next time I will be more careful